Motorcycle transport in Kent
Transportation:
We use a 9 x 5 ft fully enclosed box trailer when transporting motorcycles.
The front of the motorcycles are fastened via an adjustable front wheel clamp
which only contacts the tyre as well as a two point harness which wraps around
both handle bar grips and is then ratchet strapped to the floor of the trailer
to ensure no left or right movement without contacting any areas of paint.
We also use a front break harness which keeps the front break engaged for extra security.
To secure the rear of the motorcycle we use a harness which sits over the rear wheel
and is strapped at both sides to the floor of the trailer. These harness' only
in contact with rubber, paired together allows the motorcycle to be securely
fastened while staying up right preventing any damage or wear to any areas of paint.
Our 16.5 x 6.5 ft Tilt bed trailer sitting just 20 inches off the ground paired
with extending ramps is low enough to safely load a range of vehicles with lowering kits.
The complete flat bed flooring sitting above the wheels means there are very few vehicles
too wide or too thin for our trailer, it also allows transport for 3 wheeled vehicles such as trikes.
We have an electric winch fitted to make light work of loading and safe unloading of non running vehicles.
All vehicles are left in gear where possible with the hand break applied and are secured at all 4 wheels.
We carry wheel covers which will be fitted before fastening upon request.
The 23 x 8 ft fully enclosed curtain side trailer designed to carry vehicles as large as Bentley turbos
and Rolls Royce phantoms provides complete protection and discreet transportation. All vehicles wil be
secured using protective wheel straps which prevent any area of tension from contacting the paint
surface of the wheel.
We have an electric winch fitted to make light work of loading and safe unloading of non running vehicles.
All vehicles are left in gear where possible with the hand break applied and are secured at all 4 wheels.
We carry wheel covers which will be fitted before fastening upon request.